Tel: 18037961302
Sales hot line ( 24 hours  service): 18037961302



Adress: Luoxin Industrial Park, Luoyang, Henan
  • Products
  • Gear hardening machine

    Large diameter steel pipe quen

    Piston rod quenching and tempe

    Hand-held induction heater

    Grinding rod quenching and tem

    Induction forging machine

    induction heating machine 

    Induction heater

    High frequency induction heate

    Super audio induction heating

    Super audio induction heating

    Guideway quenching integrated

    Quenching equipment for machin

    Round steel end heating furnac

    Steel pipe heat treatment prod

    Square steel quenching and tem

    Sucker rod quenching and tempe

    Thickened petroleum steel pipe

    Round steel quenching and temp

    Steel pipe quenching and tempe

    Steel plate quenching and temp

    Induction Hardening Machine&nb

    Flywheel ring gear high freque

    Oil drill pipe quenching and t

    Iron induction furnace

    Aluminum melting furnace

    Copper melting furnace

    Small steel melting furnace

    Industrial electric furnace technical information
        Detailed configuration list of KGPS-10T induction melting furnace
    1. Electric cabinet:
    1. Phase voltage: 1500V, DC output voltage 1900V, intermediate frequency voltage: 2600V
      DC current: 3500A, power: 6500KW
      Intelligent control system
    2. KK Thyristor 1000A/2500V 48 pcs
    3. KP SCR 3500A/4000V 6
    4. Air switch 2000A / electric 2 pcs
    5. Installed copper bar 120 mm X 8 mm
    2. Capacitor cabinet:
      Capacitor 4000KF/2500V 20 sets
    Three, induction furnace
      2.3 meters X 2.3 meters, 2.5 meters high, steel shell
      Hydraulic tilting furnace system
    1. The phase-in voltage is as high as 1500v, and the DC voltage is high, which significantly reduces the loss of electric cabinets, transmission lines and power transformers.
    2. The intermediate frequency voltage is as high as 2600V, and the booster circuit is used. The voltage at both ends of the induction furnace is as high as 5200V, which greatly reduces the loss of the induction coil and the water cable.
    3. Special cooling ring for furnace bottom, durable for furnace bottom, not easy to wear, low loss at furnace bottom; using booster circuit, the voltage at both ends of the electric furnace can reach 5200V (2 times the output voltage of the electric cabinet), water cable, induction coil loss Small; 1500V phase-in voltage, reactor, equipment
    The machine copper bar and the incoming phase cable loss are small; 48 1000A/2500V KK SCRs, three sets of KK SCRs are connected in parallel, low power consumption, and the cost of purchasing KK SCRs during maintenance can be reduced by six times (if damaged Four KK3500A/2500V thyristors cost about 8500 yuan, and three sets of KK thyristors in parallel will only damage one of them under the same circumstances, and four KK1000A/2500V thyristors only cost about 1200 yuan. , Greatly reducing maintenance costs).
    4. Increase the induction furnace, and the new furnace can produce 13 tons.
    5. Intelligent system, fast protection speed, simple structure, convenient operation and easy maintenance.

    Copyright© 2007-2013 songdao Electric furnace manufacturing Co,.Ltd All Rights Reserved
    Tel:18037961302 Sales hot line ( 24 hours service): 18037961302
    Adress: Luoxin Industrial Park, Luoyang, Henan